Rhino AP-GSM

loT gateway. Reads data f rom metering devices and sensors. Equipped with multiple communication interfaces supporting most popular protocols. Includes two RF channels for wireless communication with Rhino hardware. Data transfer to the Rhino Cloud Platform via Ethernet or GSM* (SIM card pre-installed). Powered by external 5-24VDC ower supply.

Device overview

  1. Power socket
  2. Ethernet socket
  3. SMA ISM 1 antenna connector
  4. SMA ISM 2 antenna connector
  5. Configuration status LED
  6. Internet connection status LED
  7. GSM status LED
  8. SMA GSM antenna connection
  9. RS232N connection
  10. RS232 and RS485 connections
  11. Radio communication LEDs
  12. Radio communication LEDs
  13. Power status LED
Rhino AP-GSM

Technical parameters

 

Communication type Ethernet (DHCP / Static IP) or GSM (LTE / GPRS / WCDMA / HSPA)
Rhino communication Frequency range: 433MHz
ISM channel 1 – Rhino ED DI / ED DI-D / Sensors
ISM channel 2 – Rhino ED RS485 / RS232
Maximum of 50 end devices on each radio channel
Input voltage 5-24VDC ( > 10W)
Internal battery 2700 mAh (emergency power supply)
Internal memory uSD card (min. 8 GB)
Logging measurement data Yes
Interface protocols RS232 – DLMS, IEC62065
RS485 – DLMS, IEC62065, Modbus RTU, GazModem I, GazModem II
Ethernet – DLMS, IEC62025, BACnet, Modbus TCP/IP, Custom network protocols
Optional interfaces – M-Bus, Wireless M-Bus OMS
Configuration Over the Air (OTA)
Firmware update Over the Air (OTA)
Operating temperature 0˚C – 85˚C (depending upon installed environment)
IP Class IP40 (not suitable for outdoor use)
Dimensions 87.5 mm x 90.0 mm x 65.0 mm (5 DIN modules)
Weight ~0.2kg
Additional equipment 1 x ISM antenna with 3m cable and magnetic base
1 x GSM antenna with 3m cable and magnetic base (included)

Connection diagram example

Data Sheet download
Rhino AP-GSM Schema